Veris Verabar V200S Installation Instructions Manuel d'utilisateur télécharger pdf (Page 4)

Figure 6. Orientation of Flow Arrow

The Verabar is now properly installed (Figure 7).

Figure 7. Installed V200 (Single)

Periodic Maintenance

The assembly should be periodically checked. Verify

that no leaks are present. The jam nut and packing bolts

should be tight.

Sensor Removal Procedure

• Shut off instrument valves.

• Reduce flow rate to below the maximum insertion

withdrawn DP/flow limit stated on the Verabar tag.

• Loosen jam nut. Using the drive nut, retract the

sensor until the stop nut and jam nut are pressing

against the threaded bushing.

• Completely shut off the access valve. Slowly

crack open one of the Verabar instrument valves

and bleed off any remaining pressure contained in

the access nipple. The sensor assembly can now

be removed.

6315 Monarch Park Place • Niwot, CO 80503 USA • Phone: (303) 652-8550 IO -200S VWI-CS-023 REV B (6/08)

Fax: (303) 652-8552 • Email: contact@veris-inc.com • Website: www.veris-inc.com Printed in USA

1 2 3 4

Pas de commentaire

Veris Verabar V200S Installation Instructions Manuel d'utilisateur Page 4